tint-REMOTE CONTROL
INSTRUCTION MANUAL
41
4. Hold the tint remote control very close (
<
5 cm) to the new bulb.
5. Hold down the group button until the bulb begins to blink.
The feedback display will first blink red evenly; then, it will begin to blink more
quickly. This means that the tint remote control has found a signal.
The new bulb will then blink 3 times and show that it has connected to the tint
remote control. Keep holding down the group button until the bulb blinks again one
time, which shows that it has been assigned to default group(=group 1).
6. If desired, you can select a different group by repeatedly pressing the group button
(middle LED = group 2 etc.).
After approx. 10 seconds, the new bulb will be added to the selected group and the
feedback display will stop blinking. Wait this long, not pressing any buttons during
this time.
The procedure will then end and you can use the extended group as normal.
Remove a bulb from the tint remote control
1. Switch the bulb off (i.e. to standby) with the tint remote control if necessary.
2. Select the group you would like to change using the group button.
3. Hold down the group button for approx. 5 seconds.
The feedback display will blink red/green.
4. Select the desired bulb by pressing the group button repeatedly. The bulb will signal
that it has been selected by increasing and decreasing its brightness. The bulb will
blink in the order in which they are stored in the tint remote control.
5. Hold down the standby button for approx. 5 seconds.
The bulb will then signal that it has been removed from the tint remote control
by flashing and then dimming.
Add a bulb from one group into another group
1. Switch the bulb off (i.e. to standby) with the tint remote control if necessary.
2. Select the group you would like to change using the group button. (If you would like
to add a bulb from group 2 to group 1, for example, press the group button repeatedly
until the middle LED above the group button lights up).
3. Hold down the group button for approx. 5 seconds.
The feedback display will blink red/green.
4. Select the desired bulb by pressing the group button repeatedly. The bulb will signal
that it has been selected by increasing and decreasing its brightness. The bulb will
blink in the order in which they are stored in the tint remote control.
