Muller Elektronik TRACK Guide II, Инструкция по установке и эксплуатации

Страница: 69 / 80

Serial Interface application
Transfer target rates via LH5000
10
30302710-02-EN V7.20141016 69
Serial Interface application
The "Serial Interface" application is used to enable communication between the terminal and a non-
ISOBUS compatible on-board computer.
This interface enables you to use all of the applications together with the GPS signal and the on-
board computers, in order to:
▪ Transfer target rates (using the LH-5000 protocol or the ASD protocol); [
➙ 69]
▪ Switch sections on and off (using the ASD protocol). [ ➙ 70]
So that you do not need to reconfigure the application each time, you can create an individual profile
for each on-board computer.
Transfer target rates via LH5000
Tested on-board computer*
Manufacturer On-board computer Software version Baud rate
RAUCH Quantron A V1.20.00 9600
RAUCH Quantron E V3.51.00 9600
RAUCH Quantron E2 V2.10.00 9600
RAUCH Quantron S V3.90.00 9600
RAUCH Quantron S2 V1.00.05 9600
ME Spraylight V02.00.10 9600
* - Only on-board computers on which we were able to determine that the serial interface was
functional are listed. Results may differ with different software versions.

You have checked whether you need to activate the LH5000 protocol on the on-board computer.
If yes, you have activated the protocol.
1. Connect the on-board computer to the terminal. [ ➙ 16]
2. - Switch on the terminal.
3. Open the Serial Interface application:
| SerialInterf
4. - Open the list of machine profiles.
5. - Add a new machine profile.
⇨
A new machine profile appears on the screen.
6. Configure the parameters as shown in the following steps.
7. "Operating Mode" -> "Target Rate Transfer"
8. "Protocol" -> "LH5000"
10
10.1
Procedure