5. Gain Control – This feature is used to fine-tune the input sensitivity of the amplifier to the source unit’s output
level.
6. Low-Pass 40Hz-200Hz Variable X-over with 24dB per octave Slope – This control allows the user to choose the
exact low-pass frequency range the amplifier will play for the best possible performance. The upper end of
the crossover frequency point can be selected from 40Hz–200Hz at 24dB per octave.
7. ThunderEQ (Variable) – This feature will add up to 18dB of low frequency impact to the audio system. The
Bass Boost is centered at 40Hz.
8. Remote Subwoofer Level Control (Remote Gain) – This port allows the use of the optional “remote level
control”. The Remote Subwoofer Control is a bass control module that can be installed in any location within
the vehicle for remote adjustments.
9. StreetWires Connectors – All MTX amplifiers include StreetWires connectors for efficient current and
maximum voltage transfer.
10. Speaker Connection – Two sets of speaker terminals are provided for dual woofer applications. When
connecting a single woofer, use only one set of speaker terminals.
11. Power Terminals – This is the main power connection for the amplifier. The power and ground wire size
should be the same gauge.
• GND – The ground wire from this connection must be attached to bare metal on the vehicle. The distance
to the ground should be as short as possible and no more than 18”.
• REM – To turn the amplifier on/off, this terminal must be connected to the source unit’s “remote or electric
antenna” wire.
• +12V – The power wire from this connection must be attached to the positive side of the vehicle battery.
• CAP+ - Capacitor Positive Input – The ideal connection point for the positive side of the capacitor to
increase the amplifier’s performance.
CAP- - Capacitor Negative Input – The ideal connection point for the negative side of the capacitor to
increase the amplifier’s performance.•
Before Starting
MTX recommends that you have your new Thunder amplifiers installed by an authorized MTX retailer, preferably
MECP certified. If you do decide to do it yourself, make sure you have read the instructions carefully and have
the following tools:
• Electric drill
•
Phillips bit or screwdriver
• 1/8” bit
•
Wire cutters/crimpers
• Safety glasses
•
X-Acto knife
Disconnect the vehicle’s negative battery connection. Any deviation from the recommended connection
procedures may cause serious damage to the amplifier, speakers, and/or vehicle electrical system. Please
double-check the connections before turning the system on.
Installation
Mounting
Place your Thunder amplifier at the predetermined mounting location. Use a felt pen to mark the exact position
of the mounting holes on the mounting surface. Set the amplifier aside. With a sharp, precise blade cut small
circles in the carpet and padding around the four marks denoting your mounting holes to expose the metal
underneath. Use a center punch to make an indentation in the metal to ensure that you drill the exact position
for the screws.
Note: Please use common sense and make sure that all vehicle wires, gas lines, brake lines, etc. are clear and will
not interfere with the installation. ALWAYS WEAR PROPER SAFETY GLASSES.
