MTX MXA4002, Руководство пользователя

Страница: 10 / 32

Located on the Input Panel, the objective of GAIN adjustment is to match the output of the
source unit with the input of the amplifier. The output voltage of individual source units can
vary. Some source units have an output of 200 mV and others have 5 Volts or more. To cater
to these variations, the amplifier has an adjustable gain control that ranges from 100 mV to
5 volts. Adjusting this control requires some experimenting to ensure all of the gain is at the
beginning of the system, NOT at the end (amplifier). Turn your source unit up and keep your
amplifier gains at the lowest possible setting (counter-clockwise) with the maximum output.
This will give you the best sound and signal-to-noise ratio.
Besides better sonic reproduction, proper input GAIN also helps to prolong the reliability span
of your amplifier by eliminating excessive internal temperature generated by
incompatible source unit output and amplifier input.
Note : Turning the input gain up does not indicate more power. Just more noise. The input
gain control is not a power control.
If the Remote Gain is used, connect the plug of the Remote Gain to the port on the panel of
the amplifier.
1. Turn the input GAIN all the way down (counter clockwise).
2. Set the volume control of the source unit to approximately 3/4 of its maximum output.
3. Turn the balance control of the source unit to its center position (flat).
4. Leave the tone (bass/treble) controls at their usual position (flat).
5. Play a CD or tape track with great dynamic range.
6. Use the Bass Boost Control on the amp to enhance the bass performance (if desired),
not the bass on the headunit. Use this control sparingly.
7. To locate the optimum gain setting, ask the person assisting you to turn the input GAIN
control clockwise until audio distortion starts to develop. Turn the gain control back
wards slightly to minimize the distortion.
8. If you constantly switch between CD/tape and radio, you will need further adjustment
since radio output level differs from that of CD or tape. In this case, you need to locate
a balanced gain setting which is best for both the output level of radio and that of
CD or tape
SYSTEM TUNING (INPUT GAIN ADJUSTMENT)