MTX CANAM-10, Руководство пользователя

Страница: 7 / 12

M T X . C O M
7
Step 10 - Use a
5
⁄
16
" drill bit to drill through the firewall from inside the enclosure using the two existing
holes behind the subwoofer mounting hole. Remove the plastic shavings created by the drilling
process from inside the enclosure.
Step 11 - Bolt the enclosure in place using the supplied M6 hardware, tighten down until secure.
Step 12 - Using a
1
⁄
8
" drill bit, drill through the inner fender holes into the enclosure. Using the supplied
screws, secure the enclosure into place through the fender holes. Do not over-tighten the screws.
Step 13 - Connect the internal speaker wires to the subwoofer, red to positive. Screw the subwoofer
in place using the four machine screws that were removed earlier (Step 6). Using a T15 Torx, finish
securing the woofer in place using the four supplied self-tapping screws in the remaining mounting
holes.
Step 14 - Now that the enclosure is securely tightened in place, the power and signal wires need to
be connected to the battery and signal source.
• The Red wire should be connected directly to the battery’s positive terminal and fused with a
20A fuse.
• The Black wire should be directly connected to the battery’s negative terminal.
• The Blue wire should be connected to the ACC / Key Turn On.
Step 15 - Connect the RCA inputs to the signal source of your choice
Step 16 - Turn the unit on and check to make sure everything works. Set the gain using the gain pot
that is attached to the orange/grey wires. Set the gain to the bass level desired.