MTS Systems Ultimate TV, Руководство пользователя

Страница: 36 / 59

33
Black MXv3 (RF) remote:
1. Turn on the device you want to control and point the remote at that device
2. Press and hold the mode key (i.e.
TV , DVD , or AUX ) you want to program
3. Without releasing the selected mode key (i.e. TV , DVD , or AUX ), press and hold the OK key simultaneously
4. Release both the mode key (i.e., TV , DVD , or AUX ), and the OK key – all of the mode keys will fl ash, then the
selected mode key light will stay lit
5. Press the power button repeatedly until the selected device turns o ff . Once your device has turned o ff , press OK
to save the code
6. To indicate a successful setup, the selected mode key will turn o ff and you are ready to setup another device by
following steps 1 thru 4 of this section
Silver/Charcoal remote:
1. Turn on the device you want to control and point the remote at that device
2. Press and hold the mode key (i.e.
TV , DVD , or AUX ) you want to program
3. Without releasing the selected mode key (i.e. TV , DVD , or AUX ), press and hold the OK key simultaneously
4. Release both the mode key (i.e. TV , DVD , or AUX ), and the OK key – all mode keys will fl ash twice indicating
programming mode
5. Enter 922 by pressing the number keys on the remote control
a. The selected mode key ( TV , DVD , or AUX ) will fl ash twice indicating correct entry
b. For AUX searching only, press and release the PLAY key then press:
• 1 for VCR
• 2 for Receiver/Tuner
• 3 for Ampli
fi er
• 4 for Home Theatre in the Box (HTIB)
The AUX mode key will fl ash twice indicating correct entry
6. Press and hold
PLAY key and wait until the device turns o ff , then release the PLAY key
a. The REW key can be used to go back through the codes one at a time
b. The FF key can be used to move forward through the codes one at a time
7. To save the code press the ENTER key on the remote control or press the EXIT key to return to normal operation.
The selected mode key will fl ash three times and return to normal operation
8. If no valid code is found, the green backlight will fl ash twice and the remote control will return to normal operation
9. Turn the device back on and use the remote to control your device. Now that your devices are programmed you
can press the appropriate mode key on the remote control to work with the selected device. To use the remote
control for your Set Top Box again, press the
STB/MT S mode key
Note: If any other key is pressed except PLAY , ENTER , POWER , EXIT , REW , FF or number keys 1 to 4 the selected mode key will give a
long red fl ash (error message) and the remote control will return to normal operation and you will need to start over.
If you are interrupted while you are programming, the remote control may time-out before you complete the code setup and you will
need to start over. A remote time out is indicated by two quick
fl ashes of the green backlighting.
User Tip: You may need to repeat steps 1 through 8 to fi nd a code.