MTL 9469-ETplus, Инструкция по эксплуатации

Страница: 11 / 16

7 INM9469-3
June 2012
Security
64/128 bits WEP, WPA-PSK, WPA2-PSK, IEEE 802.11x (RADIUS) authentication, MAC address
filtering, SSID broadcast control.
Modes
Access Point (AP) for WiFi Network Infrastructure, Bridge mode to connect any 10/100 wired
Ethernet equipment to a wireless network, Repeater (WDS) mode to extend wireless coverage,
Infrastructure & AD-HOC modes are supported.
Administration
Built-in Web interface. Setup of the device using a web browser.
14 ACCESSORIES
For interconnecting the 9460-ET range of products, we offer approved RJ45 Cat5e UTP cables in
various standard lengths (0.5…100m).
The ANTSMA94 omnidirectional antenna is ideal for use where good general coverage is required.
Ordering details
Copper Twisted Pair UTP Patch Cable (Blue) pre-terminated RJ45-RJ45 connectors
Part No. CSL9405-xx
( -xx is used to signify the length of the cable.)
Part No. ANTSMA94 Omnidirectional antenna
15 APPROVALS
The operating parameters must not exceed those as detailed on the certificate.
♦ 2004/108/EC EMC Directive
♦ 2006/95/EC Low Voltage Directive
Region Europe (ATEX) International IECEx USA Canada
Authority SIRA SIRA FM FMC
Standard EN 60079-0: 2006,
EN 60079-11: 2007,
IEC 60079-26: 2006,
EN 50303: 2000,
IEC 61241-0: 2004,
IEC 61241-11: 2005
IEC 60079-0: 2004,
IEC 60079-11: 2006,
IEC 61241-0: 2004,
IEC 61241-1: 2005
3600: 1998
3610: 2007
3810: 2005
C22.2 No. 61010.1: 2004
C22.2 No. 157: 1992
CAN/CSA-E60079-0:
2007
CAN/CSA-E60079-11:
2002
Approved for E I M1
E II 1GD
Ma Ex ia I
Ga Ex ia IIC T4
Ex iaD 20 T135°C
(Ta = –40˚C to +60˚C)*
Ma Ex ia I
Ga Ex ia IIC T4
Ex iaD 20 T135°C
(Ta = –40˚C to
+60˚C)§
IS/I/1/ABCD/T4 Ta=60°C
I/0/AEx ia IIC T4
Ta=60°C
IS/I/1/ABCD/T4 Ta=60°C
I/0/Ex ia IIC T4 Ta=60°C
Cert. no. Sira 07ATEX2064X IECEx SIR 07.0042X 3034995 3034995C
* (see specification for operating temperature range)
16 FM CERTIFICATION INFORMATION
Special Condition of Use - Factory Mutual (USA & Canada)
♦ The Model 9469-ETplus shall be installed in compliance with the enclosure, mounting, spacing
and segregation requirements of the ultimate application.
♦ The Model 9469-ETplus shall be excluded from use in environments containing chemical
vapours of the Ketone or Ester families.