M.T.H. HO 4-6-4 Empire State Express Steam Engine
3
QUICK START GUIDE
Of course, you should read your manual over before running your M.T.H.
HO Steam Engine. But if you just can’t wait, choose how you want to run
below and enjoy!! Now, after a few minutes, shut her down and read through
your engineer’s guide.
I USE A REGULAR DC SUPPLY…
Step 1: Unpack your Engine and Tender. (refer to unpacking instruction
on pg 4)…
Step 2: Set the engine on the track …
Step 3: Apply increasing
DC
voltage until she starts up and pulls out!
I'M A DCC OPERATOR….
Step 1: Unpack your Engine and Tender. (refer to unpacking instructions
on pg 4)…
Step 2: Set the engine on the track …
Step 3: Power up your DCC system…
Step 4: Select engine address 3 and press “F3” to start her up…
Step 5: Turn the throttle and head on down the pike…
I RUN DCS….
Step 1: Unpack your Engine and Tender. (refer to unpacking instructions
on pg 4)…
Step 2:
Set the engine on the track …
Step 3:
Power up your DCS system…
Step 4:
Add the engine to your system and start her up…
Step 5:
Turn the throttle and move out….
CAUTION:
M.T.H. HO engines
DO NOT OPERATE ON AC VOLTAGE
.
Applying AC power to your locomotive could cause permanent damage and will
void your warranty.
