MTD Yard Machines 450 Series, Руководство оператора

Страница: 8 / 36

8
WARNING:
Do not put fingers under the
belt cover.
If the belt turns without bail engaged,
adjust by
unthreading the internally threaded tube at the end of
the cable a few turns clockwise (when standing in
operator’s position), and then retighten the nut against
the tube.
Now move the shift lever to FORWARD (Wheels
Forward) position. Carefully engage the clutch by lifting
the clutch control bail against the handle. The wheels
should spin.
If the wheels do not spin with the unit in forward,
adjust by unthreading the tube at the end of the cable a
few turns counter-clockwise, (when standing in
operator’s position), and then retighten the nut against
the tube.
Recheck both adjustments, and readjust as necessary.
NOTE: A secondary cable adjustment is available if
you reach the point that additional adjustment is
needed. Remove the belt cover and move the hex nuts
at the other end of the cable towards the end of the
casing. Then readjust the hex nuts at the handle.
TIRE PRESSURE
The tires on your unit may be over-inflated for shipping
purposes. Reduce the tire pressure before operating
the unit. Recommended operating tire pressure is
approximately 20 p.s.i. (check sidewall of tire for tire
manufacturer’s recommended pressure).
WARNING:
Maximum tire pressure
under any circumstances is 30 p.s.i. Equal
tire pressure should be maintained on
both tires.
SECTION 4: CONTROLS
THROTTLE CONTROL
The throttle control lever is located on the engine. It
controls the engine speed and stops the engine. See
Engine manual for further information.
CHOKE LEVER
(if equipped)
The choke lever is located to the left of the throttle. It is
used to enrich the fuel mixture in the carburetor when
starting a cold engine. See Engine manual for further
information.
Figure 6
GEAR SELECTION HANDLE
The gear selection handle is located in the center of
the handle on the tiller. It is used to select NEUTRAL,
REVERSE, or one of the FORWARD modes (see
below). Pull or push the handle so that the indicator on
top of shift cover points to the operating mode desired.
See Figure 6.
NEUTRAL
—Transmission is in neutral.
REVERSE
—Reverse wheel drive.
FORWARD Modes
:
Wheels Forward
— Forward wheel drive only.
Tines Reverse
— Forward wheel drive and reverse
tine drive.
Tines Forward
— Forward wheel and tine drive.
IMPORTANT:
Use the reverse tine drive when
tilling virgin ground, sod, or hard soil. Use the forward
tine drive when cultivating or tilling soft ground.
NOTE:
If difficulty is encountered in moving the gear
selection handle, move the tiller forward or backward
slightly to allow the gears to synchronize.
• To shift into forward or reverse wheel drive,
move tiller forward slightly then backward to
allow the gears to synchronize.
• To shift into forward wheels and tine drive, push
forward slightly on the gear selection handle and
slowly engage the clutch control allowing the
gears to synchronize.
• To stop forward movement and tine drive,
release the clutch control. Do not shift gears
with the clutch control engaged except when
engaging the tines.
WARNING:
Make certain unit is in
NEUTRAL when starting the engine.
Height
Adjustment
Lever
Control
Rod
Gear
Selection
Handle
Clutch
Control
Bail
Clutch
Cable
Cable Tie