MTD 699 Series, Руководство оператора

Страница: 7 / 24

7
SECTION 3: ASSEMBLING YOUR LAWN TRACTOR
NOTE: This manual covers various models of
hydrostatic tractors within the 690 series. Please use
instructions pertaining only to your tractor.
Unpacking
• Remove all screws from top of the crate using 1/4"
hex head socket or a flat blade screwdriver.
• To remove ends, grasp top board on the end, and
pull towards you in downward motion. (A hammer
may be helpful). Set panel aside to avoid tire
damage.Repeat procedure on other sides.
• Remove and discard plastic bag which covers unit.
• Loose parts (may include the owner’s guide,
steering wheel, optional oil drain sleeve or hose,
battery fluid, chute deflector, optional mulching
plug, etc.) are on the seat or in a box wrapped in
plastic. Carefully cut and remove the plastic wrap.
Remove the loose parts.
• Make sure that parking brake and hydrostatic
transmission relief valve are released and unit is in
neutral. See page 11-12 for the location of the
parking brake release and the hydrostatic relief
valve.
• Raise the deck and push the unit off the skid.
NOTE: Reference to right or left side of the unit is
observed from the operating position on the driver’s
seat, facing forward.
Tools Required
1. Socket wrench 1/4" or flat blade screwdriver
2. Adjustable or socket wrench 1/2" *
3. Adjustable or socket wrench 9/16"
4. Pair of adjustable or socket wrenches 7/16"
* If your tractor steering wheel cap is square, you must
use a socket wrench to install the steering wheel.
Handling Battery
WARNING: The battery contains sulfuric
acid. This battery acid must be handled
with great care as contact with it can burn
and blister skin. Wear protective clothing
(goggles, rubber gloves and apron) when
working with it.
Keep batteries out of the reach of children.
IMPORTANT:
Should battery acid accidentally splatter
into the eyes or onto the face , rinse the affected area
immediately with clean, cold water. Refer to the
antidotes mentioned below. If there is any further
discomfort, seek prompt medical attention.
Antidote
Use the following antidotes if you come in contact with
the battery acid.
EXTERNAL — Flush with water.
INTERNAL — Drink large quantities of water or milk.
Follow with milk of magnesia, beaten eggs or vegetable
oil. Call physician immediately.
EYES — Flush with cool water for at least 15 minutes,
then get prompt medical attention.
If acid spills on clothing , first dilute it with clean water,
then neutralize with a solution of ammonia/ water or
baking soda/water.
IMPORTANT:
Since battery acid is corrosive, do not pour
it into any sink or drain. Before discarding empty
electrolyte containers, rinse with a neutralizing solution.
WARNING: To avoid sparks, NEVER
connect or disconnect charger clips to
battery while charger is turned on.
Keep all lighted materials (cigarettes,
matches, lighters) away from the battery
as the hydrogen gas generated during
charging can be combustible.
As a further precaution, only charge the
battery in a well-ventilated area. Make
certain venting path of battery drain tube
(if equipped) is always open.
Identifying Battery Type
Figure 1
Type "A"
Type "B"