MTD 33 27JD Series, Руководство оператора

Страница: 10 / 80

10
SET-UP
7. Connect the headlight wire terminals (a). Slide the pedestal
cap (b) down onto the riding mower and slightly rotate to the
right to clip into place. Secure the pedestal cap (b) with the
screw (c) previously removed (Figure 3 on page 9).
Installing Operator’s Seat
1. Remove the shoulder bolts (a) and lock nuts (b) from the
seat mounting bracket (c) included in your hardware pack
(Figure 4).
c
b
b
a
a
Figure 4
2. Remove the two self-tapping bolts (a) factory installed on the
riding mower (Figure 5).
a
a
Figure 5
3. Align the seat bracket (a) in place over the holes from where
the self-tapping bolts (b) were removed (Figure 6).
a
b
b
Figure 6
4. Using a 1/4 inch drive ratchet with a 3/8 inch socket, secure
the seat bracket (a) with the self-tapping bolts (b) removed
in Step 2 (Figure 6).
CAUTION
Do not use any type of power tool (e.g. impact gun or
electric drill with nut driver attached) when tightening
the self-tapping bolts to attach the seat bracket.
5. Position the seat assembly over the seat mounting bracket,
aligning the holes provided (Figure 7).
a
b
b
a
a
b
c
c
d
Figure 7
6. Install the two shoulder bolts (a) and lock nuts (b) removed
from the seat mounting bracket (c) in Step 1 (Figure 7).
NOTE:
Make sure the bolt’s shoulder is completely recessed
into the seat bracket when securing the lock nut.
7. To adjust the position of the seat, loosen the adjustment
knob (d) on the bottom of the seat. Slide the seat forward
or backward as desired. Securely re-tighten the adjustment
knob (Figure 7).
WARNING
Never operate this riding mower without either the
mulch plug or deck chute installed.
Installing the Deck Chute
1. Remove the wing knobs (a) installed on the mowing deck and
retain for later installation (Figure 8).
c
d
a
b
a
c
e
f
g
Figure 8