9
13.12.Reassemble the side plates with a replacement
rubber ring.
IMPORTANT:
Tighten each screw only one rota-
tion before turning the wheel clockwise and pro-
ceeding with the next screw. Repeat this process
several times to ensure the plates are secured
with equal force.
13.13.Slide the friction wheel assembly back onto the
hex shaft and follow the steps above in reverse
order to reassemble components.
14.
AXLE SHAFT REMOVAL
14.1. Follow steps 11.1 through 11.5 in the AUGER
BELT REPLACEMENT Section.
14.2. Using a ½” socket remove the screws and bell
washers securing the wheels to the axles.
Remove both wheels.
14.3. Remove the extension spring from friction wheel
support bracket. See Figure 26.
Figure 26
Friction Wheel
Suport Bracket
Extension Spring
14.4. Use a 7/16” socket and back off the screw secur-
ing the cable roller to the guide bracket. Do not
remove the screw. Slip the cable over the roller.
See Figure 27.
14.5. You can now easily remove the drive cable
spring from the support bracket.
14.6. Remove both “E” clips from the axle shaft. See
Figure 27
Cable Roller
Figure 28
“E” Clip
“E” Clip
