MTD 19A70034OEM, Руководство оператора

Страница: 14 / 20

14 S
ECTION
4 — A
SSEMBLY
& I
NSTALLATION
Installing the Discharge Chute
1. Reinstall cutting deck onto the tractor reversing the instructions
for Deck Removal in operator’s manual of the tractor.
2. Raise the deck to its highest position.
3. Raise the chute deflector (A in Figure 4-24) on the deck and
hold it while you position the discharge chute over the
chute opening.
4. Insert the hinge pin of the discharge chute into the tube on
UIFDIVUFTUPQCSBDLFU4FF#JO'JHVSF
5. Rotate the chute around the deck so that its front edge fits
snugly into the deck opening. Lower the chute deflector
slowly (C in Figure 4-24).
A
C
B
Figure 4-24
6. Attach the retainer strap on the discharge chute to the
retainer clip on the deck. Refer to Figure 4-25.
Note:
For the chute elbow to be properly installed, the bottom
edge must fall
over
the bottom of the deck opening and the tab
on top of the elbow should rest above the deck opening.
IMPORTANT: If the retainer clip is not present on the mowing deck, on
TPNFVOJUTPOFIBTCFFOJODMVEFEXJUIIBSEXBSFQBDL
"UUBDIUIFSFUBJOFSIPPL XJUIBTFMGUBQQJOHTDSFXGBDUPSZ
installed in the deck in the position noted in Figure 4-25. Remove the
screw in the deck and reinstall with the retainer hook.
Figure 4-25
7. Install the upper chute tube onto the chute elbow by
lining up the rubber strap on the upper chute tube with
the pin installed on the chute elbow, as shown in Figure
4-26. Secure the upper chute tube to the chute elbow by
hooking the rubber strap onto the deck pin as shown.
Figure 4-26
8. With the bagger cover open, pivot the upper chute tube
into position so that the chute rests in the upper chute
support. See Figure 4-27.
Note:
Make sure to align the upper chute with the ridges
on the upper chute support.
Close the grass catcher cover.
Figure 4-27
10. With the chute installed in its proper orientation and the
deck set in the lowest cutting position, tighten both hose
clamps on the flexible tube extension, making sure the
clamps are still positioned over the rubber adhesive strips.