3.2.
Preparations for use
INSTALLING THE PRODUCTS
Before covering the vehicle, make sure that there will be nothing under the car
cover which could damage it or the vehicle.
1.
The cover features a label with the text “FRONT”. Put this end of the
cover over the front bumper fascia/cover.
The cover edging is flexible to
keep the cover in place.
2.
With the end of the cover secure over the front bumper fascia/cover, continue
covering the vehicle moving towards its rear.
3.
Before covering the rear of the vehicle, open the boot/trunk and locate the
boot strap included with the car cover. Put the boot strap over the boot latch.
Close the boot/trunk and put the flexible edging of the cover over the rear
bumper fascia/cover.
4.
Each car cover features grommets on both ends for lashing. The system of
straps and buckles helps to secure the car cover in place.
5.
The car cover features a self-adhesive patch to seal the opening to be made
for the vehicle’s fixed antenna. Instructions for use: when covering the car,
mark out on the cover’s surface where it covers the vehicle’s antenna. Apply
the self-adhesive patch to the marked location and open a hole in it to pass the
antenna through.
3.3.
Cleaning and maintenance
a)
Use non-corrosive agents for cleaning the surfaces only.
b)
After each cleaning, dry all components well before the product is used again.
c)
Store the product in a dry and cool place, protected from moisture and direct
sunlight.
d)
Regularly inspect the product for technical defects and damage.
e)
Use a soft, damp cloth for cleaning.
