WRN wireless repeater node
MST
Owner’s Manual
Revision 1.7
– 26 April 2018
© Mine Site Technologies Pty Ltd 2017
Commercial in Confidence
6
User Controls and Indicators
Power button
Press the button in the middle of the front panel to turn WRN on. Holding the button while
turning WRN on will cause a factory reset, which may take up to 5 minutes.
WRN status indicators
- Mesh / Uplink quality indicator. Green: healthy (>-65dB). Orange: moderate (-
65…75dB),
Red: poor (<-75dB). Flashing at 50% duty cycle: establishing mesh. Flashing rarely: no
mesh, Flashing with any colour: indicates data transfers
- Wi-Fi Access Point. Flashing green: indicates data transfers. Stable light: idle. Disabled
Access Point: LED off.
- Power. Green colour. LED indicates that the power is on. Hardware controlled.
- Tracking tag. Flashes blue when tag broadcasts are received.
- Fault. Steady Red in fault condition.
Battery status indicators
Central moving green bar indicator shows charge status in 20% increments. Bar indicator turns
red when 12 hours of charge is left. Battery indicator turns red and starts flashing when WRN is
about to switch off due to the lack of charge.
Flashing red bar
Glowing rim indicates that the battery is in use:
In use
Flat battery
The battery with the lowest remaining charge has the priority and gets connected on the power
up. After it is depleted and its indicator turns red the second battery gets connected instead.
When both batteries are depleted, with just one red bar remaining they both switch on and
continue powering WRN until the power is fully depleted.
