19
operation for safety concern. It cannot be operated within 10 minutes after shutting down.
Attention:
The bubble function can only be activated when the inflation knob is in <OFF> position.
Adjustment Buttons:
Press UP or DOWN button, the screen flashes setting temperature. Re-set
the temperature within 3 seconds. Otherwise the temperature setting mode will end automatically. If
the other button is pressed during the setting , the setting will also stop. The current temperature
shown on the screen is confirmed.
NOTE:
The default temperature is 100°F (38°C).
NOTE:
Temperature adjustment ranges from 68°F (20°C) to 104°F (40°C).
Controller Locking:
Press UP and DOWN button at the same time for 3 seconds, the buzzer will ring
3 times, meaning that the controller is locked. In this mode, the function will not be turned on if the
button is pressed. Press UP and DOWN button at the same time again for 3 seconds to unlock the
controller.
Timer Button:
Press the TIMER button to enter the intelligent pre-setting mode. By press UP and
DOWN button, you can set and start heating automatically within up to 99 hours. The TIMER setting
is confirmed if no further operation in more than 3 seconds or press TIMER button again. The heater
will start working after current setting hours. The setting hour can also be changed by entering the
pre-setting mode again. The light of TIMER button flashes
green
when activated.
Cancel:
Press the TIMER button for 3 seconds to cancel the pre-setting.
NOTE:
The pre-setting function cannot be turned on during heating process. The pre-setting mode
will also end once the heating function is on or after the spa is reboot.
Celsius/Fahrenheit Toggle Button:
The temperature can be displayed in either Celsius or
Fahrenheit.
Ozonator Button:
Activate the Ozone. The Ozone icon shows green when the Ozone function is
activated. For bathers' safety concern, the ozonator cannot be operated at the same time when the
Bubbling or Jet function is on. The Ozonator will be off automatically after operating for 2 hours. The
ozone output is 10-30mg/Hr.The filter will be activated automatically when ozonator is running. It
cannot be shut down during this period.
NOTE:
Please do not soak in the spa when the Ozone is on. The Ozonator will not work when the
spa has no water or when the Bubble Button is on.
UP
DOWN
TIMER
Filter Cartridge Cleaning Reminder: When the red light keeps flashing (Filter function is
OFF) or red and green lights are alternately flashing(Filter function is ON), the filter cartridge
shall be cleaned or replaced. After that, press Filter button for 3 seconds to clear the
reminder.
IMPORTANT: The following conditions will lead to slow water heating
● The ambient temperature is lower than 10°C(50°F)
● Outdoor wind speed is above 3.5-5.4m/s(8-12mph)
● The air bubble function is activated when heater is on
● The spa is not properly covered with the spa cover when the heater is on
