10
O-rings
Air pipe
Connect the control panel to the spa tub. Fasten and secure the rings to
the pipe adapter on the spa tub. (Fig.4)
Make sure the rubber O-rings are
properly placed on the air pipes.
CAUTION:
Lost of the O-rings may result spa and the bubbling function
working improperly, and also cause the air pump rusted.
NOTE:
For spa models has PVC leather covers, make sure the spa cover
is onto the spa tub properly before connecting the control panel. The two
holes on the leather cover must be positioned correctly to the pipes of
control panel air pipes.
5.
5
11
Spa Inflation.
6.1 Unscrew the air valve cap (a) on the control panel to reveal the air blower inflation outlet and connect one end of the inflation
hose (b) to the outlet. See Figure 6.1
6.2 Unscrew the air valve cap on the spa pool and reveal the stem for inflation.
6.3 Connect the other end of the inflation hose (b) to the manometer (c) first and then insert to the air valve.
6.4 Press the Bubble button to inflate the spa tub until it is firm to tough.
CAUTION:
Do not over inflate. Over inflation may cause spa leakage and void the warranty.
6.5 Pay attention to the Manometer. The
Yellow
section appears when the spa is properly inflated. The
Green
section shows
when water filling is completed. Repeat previous steps if more air is necessary.
CAUTION:
The
Red
section shows when the spa is over inflated. Press the black button (a) on the manometer to release
some air until it points the green section.
IMPORTANT:
During spa use, the manometer shall only shows the
Green
section at all times.
6.6 When inflation is completed. Press Bubble button again to turn it off. Disconnect the inflation hose on both ends.
Replace the air valve cap back.
NOTE:
6.
6.1
6.2
6.3
6.4
6.5
Green
Yellow
Over Inflation
Red
Button
(a)
(b)
(b)
(c)
(a)
