16
5. Connect the control panel to the spa tub. Fasten and
secure the rings to the pipe adapter on the spa tub. (Fig.5)
Make sure the rubber O-rings are properly placed on the
air pipes.
CAUTION:
Lost of the O-rings may result spa and the
bubbling function working improperly, and also cause
the air pump rusted.
NOTE:
For spa models have PVC leather covers, make
sure the spa cover is onto the spa tub properly before
connecting the control panel. The two holes on the leather cover must be positioned correctly to the pipes
of control panel air pipes.
6.
Spa Inflation
6.1 Unscrew the air valve cap (a) on the control panel to reveal the air blower inflation outlet and connect
one end of the inflation hose (b) to the outlet. See Figure 6.1
6.2 Unscrew the air valve cap on the spa pool and reveal the stem for inflation.
6.3 Connect the other end of the inflation hose (b) to the manometer (c) first and then insert to the air valve.
6.4 Press the Bubble button to inflate the spa tub until it is firm to tough.
CAUTION:
Do not over inflate. Over inflation may cause spa leakage and void the warranty.
6.5 Pay attention to the Manometer. The
Yellow
section appears when the spa is properly inflated. The
Green
section shows when water filling is completed. Repeat previous steps if more air is necessary.
CAUTION:
The
Red
section shows when the spa is over inflated. Press the black button (a) on the
manometer to release some air until it points the green section.
IMPORTANT:
During spa use, the manometer shall only shows the
Green
section at all times.
6.6 When inflation is completed. Press Bubble button again to turn it off. Disconnect the inflation
hose on both ends. Replace the air valve cap back.
NOTE:
internal inflation system of the valve to come loose.
release some air and stop until the manometer points to the right color section.
O-rings
Air pipe
5
11
6.1
6.2
6.3
(a)
(b)
(b)
(c)
1 0 4
F
6.4
6.5
Green
Yellow
Over Inflation
Red
Button
(a)
