Red +
Black -
+
__
-
-
1.
2.
+
4. Trim Wire
Trim the wire to the appropriate
length and connect the positive (+)
leads on the input wire with the wire
nut. If daisy-chaining, connect the
positive (+) wire for the next speaker
in the chain. Repeat for negative (-)
leads.
~6-8”
~8”
1. Digging
Dig a hole sufficient to bury the
speaker(s) to the correct depth
(noted above) in the precise location
where the speaker will be placed.
2. Strip Wire
Strip and prepare wire ends for your
speaker configuration.
3. Thread Wire
Pass the wire from the amp through
the side hole in the mounting spike
and out the top end. Repeat this
process if daisy-chaining. Do NOT
pass the speaker wire(s) out of the
bottom of the mounting spike.
Back
8. Fine-Tune Aiming
Angle the speaker in your desired
position with the allen wrench.
Loosen screw in the bottom of the
gooseneck and gently rotate. Re-
tighten when angled properly.
5. Screw on Spike
With the speaker wires inside the
spike, begin threading the speaker
until it’s tight. Gently pull on the
speaker wires coming out of the
side to remove any excess wire.
7. Position Speaker
Position the speaker in the desired
direction in the hole. The speaker
should be deep enough that the
wire(s) can be buried at least 1”
below the ground. Backfill the hole.
6. Test
Fully wire the rest of your system
and test to make sure sound is
coming from each unit.
9. Vertical Aiming
Adjust angle by loosening the screw
on the side of the mounting bracket.
Adjust speaker to the desired angle
and re-tighten screw. Do NOT angle
speaker more than 45°.
Mylar Film
11. Mylar Film
Remove the mylar film from under
the tap switch knob by pulling on
the exposed tab. Push the tap
switch onto the speaker to lock into
position.
10. Tap Switch Settings
See the tap switch key on page 3 to
determine which tap power setting
corresponds to the markings on the
speaker and select accordingly.
Side View
Back View
Note:
To reset the tap position after the
knob has been locked in place,
gently pry the tap switch knob 1/8”
from speaker. Re-position the tap
switch to the desired setting and
then push the knob back in place
to be locked in its new position.
If desired, the tap switch locking
mechanism may be permanently
disabled by cutting off the short
pin on the back of the speaker.
Simply remove the tap knob, cut off
the locking pin on the back of the
speaker and replace the knob.
PERISCAPE INSTRUCTIONS
