MS ENERGY eBike c500, Инструкция по эксплуатации

Страница: 390 / 424

ENG
25
6. OTHER ASSEMBLY METHODS (options)
Installation of Headlight (option)
Close the whole power supply, avoid the
positive and negative pole of the lamp wire
from short‐circuit, install the head light, and
do not pull the head light, in order to avoid
the lamp wire from shedding, causing
unnecessary trouble.
1. Take out the Headlight and the front
fender;
2. Align the hanger of the front fender with
the hole of the Headlightrack
3. Fix the hexagonal M6 × 16 bolt inside the screw hole of the Front fork with 10mm
opening wrench, and tighten the bolt.
Note : some models of front fender sticks need to be installed on the front wheel axis.
Installation of quick release front wheel and V brake *
1. Take out the front wheel, and rotate the quick
release handle for laps counterclockwise.
2.
Remove the black plastic rack below the Front fork,
and take the V brake conduit out of the V brake,
and put the front wheel axis into the Front fork
foot contact pin.
3. Rotate the quick release handle for laps clockwise
and lock the quick release handle to ensure the
front wheel can not be loose;
4. Extrude the V brake by force, and put the V brake
conduit into the V brake.
5. Pinch the Brake handle repeatedly, and check
whether the two brake blocks have the same gap
as the rim, and if the gap is uneven, re‐debug the
V brake (Please refer to Chapter 4 for the specific
debugging method).
Note
: When tightening the quick release handle
of the front wheel, press the Front fork by force
downward, so that the front wheel axis can work
closely with the Front fork.
* Option, only models with V-Brake system
1
2
3
2
1
3
4
5
3
2
1