MRV Communications LX-8000 Series, Руководство пользователя

Страница: 23 / 65

451-0331
MRV Communications, Inc. www.mrv.com
23
Installing the LX-8000 Series
These passwords prevent persons who do not know them from accessing the server. Change
the default passwords to other values as part of your basic server setup. You can use any
character or number in a password. However, backspace, tab, and escape are not supported.
Refer to the “Password Enable” section in the Subscriber chapter of the
LX-Series Commands
Reference Guide for information on changing passwords.
Resetting the Unit
To reset the LX-8000 Series, use a paper clip to momentarily press the reset button, which is behind
the small hole labeled
R
on the front panel. Refer to Figure 8 for the exact location.
Figure 8 - LX Series RESET Switch Location
When the LX-8000 Series enters the RESET state, all front panel LEDs illuminate. When you release
the reset button, the unit begins to execute the Power On Self Test (POST).
If the LX-8000 Series detects an error, the red
FLT
LED comes on and the front panel LEDs light up
to display an error code. This error sequence is repeated continually until the error is corrected or you
power off the unit. During this time, no data is exchanged over the Ethernet cable or serial ports.
If the LX-8000 Series does not detect an error, the unit begins loading software from the internal
flash. Once loaded, the LX-8000 Series resumes normal operations.
IMPORTANT
Take steps to ensure that the password is not lost or forgotten. If you forget
the password, call Customer Support.
Reset Switch