Assembly of Support Brackets Mounts
Page 4
mrcool.com
2
Begin the installation process by assembling the support bracket mounts.
1.
Take one of component C and one of component D. Using
Fig. 2.1
below as a guide, stand component C
upright and insert component D into the bottom of component C. Make sure to align the four bolt holes
(two on each side) at the bottom component C with the corresponding holes of component D. Component
C and component D should be perpendicular from one another creating an “L” shape.
2.
Insert two bolts (Component M8x55 M-B) completely through the holes and thread nuts (Component M8
M-D) onto the end of each of the bolts by hand. Then, using a wrench tighten the nuts until secure.
DO NOT
overtighten the nuts, as this could damage and possibly weaken the support bracket.
3.
Insert component E into the hole at base of the rear of component C. Please refer to
Fig 2.2
.
4.
Next, take two bolts (component M8x25 M-A) and place washers (component B) onto them. Then, insert the
bolts with washers into the front and rear slide holes on the top of component D. Next, put washers
(component M-C) on the ends of each bolt and then secure with nuts (component M-D).
DO NOT
overtighten the nuts.
Please refer to
Fig. 2.1.
5.
This completes the assembly of one support bracket mount. Repeat the same process for the second
support bracket mount.
Fig. 2.1
Fig. 2.2
M8X55 M-B
M8X25 M-A
M8 M-D
D8 M-C
M8 M-D
Component C
Component D
Component E
Component B
