MRC INE-DDBJ-350, Инструкция по эксплуатации

Страница: 5 / 31

1.2.3 Accessories
Accessories Diagram (Figure 3)
1. The conductive probe
2. The ATC probe
3. The charger
4. The USB cable
1.3 Installation
Open the meter package, take out INE-DDBJ-350 portable conductivity meter and
related accessories.
1.3.1 The installation of measuring electrode
1.3.1.1 The installation of conductive probe
Find measuring electrode socket (8 pins) above the meter (Mini type socket,
pay attention to the number of pins, don’t mistake with temperature
socket), insert the conductive probe (pay attention to the direction).
1.3.1.2 The installation of temperature electrode
Find temperature electrode socket (6 pins) above the meter (Mini type
socket), insert the ATC probe (pay attention to the direction).
1.3.2 The installation of power charger
The meter uses lithium batteries(Li-on), supplied with a charger.
To connect the USB cable and the charger, and then insert the other end of
the charger into the AC power.
This charger is suitable for the following power supply:

Input: 100~240VAC, 0.15A, 50/60Hz;
 Output: 5VDC, 1A.
CAUTION:
1 This charger is only used to this meter, it is not recommended to use it on other kinds
of meters, also other kinds of charger is not recommended.