MRC DRS4000, Руководство пользователя и техническое руководство

Страница: 55 / 88

Routine Operation 2-39 DRS4000 Receiver User and Technical Manual
4. Use the Site Management pull-down menus to select
On or Off option for each site, as required, and select
the Change option button.
2.13.10 Change BDC/RF Switch Matrix
The procedure required to select block downconverter (BDC)
types, to select BDC power, and to change the RF switch matrix
is contained in the following steps.
1. Verify the DRS4000 is connected to the remote PC
per
“Connect to the Web Browser” on page 2-34 .
2. Select the System Configuration tab.
3. Select the Matrix/BDC Setup tab. See Figure 2-56 .
Figure 2-56: System Configuration Tab - Typical
CAUTION Do not change BDC types UNLESS the BDC
type has actually been changed.
If BDC type selected is not contained in the
system, equipment damage will occur!
4. Use the BDC Configuration pull-down menus to
select the type and power settings, as required, and
select the corresponding
Change option button(s).
Note If the same input option is selected for more than one
source, the settings will be rejected when the
Change
option button is selected.
5. Use the RF Switch Matrix pull-down menus to select
the inputs required and select the Change option
button.
2.13.11 Change/Monitor Camera Settings
The System Configuration - Camera Settings tab options are
not currently active.
2.13.12 Select New Preset
The procedure required to select a new Preset is contained in
the following steps. When a new Preset is selected during
performance of this procedure, the selected Preset settings will
be displayed in the
Preset Details section of the Presets page
as soon as the Change option button is selected.
1. Verify the DRS4000 is connected to the remote PC
per
“Connect to the Web Browser” on page 2-34 .