13
1
" hole
Installing the eTempo
®
or eTempo/Plus
®
Control
1. Firmly connect the connector to the control.
Turn on power to the steam generator and test
the control to verify correct connections. Test
per instructions. Proceed with installation and
verification of proper control function.
IMPORTANT:
Turn power to the steam generator
OFF before installing the control. Failure to turn
the power off will result in an inoperable control.
2. Remove & discard peel-off paper to expose
adhesive liner
3. Run a bead of silicone (provided) as shown to
the C shaped groove.
IMPORTANT:
Do not apply excessive amounts of
silicone. Do not apply silicone to any other parts
of the control including the adhesive gasket.
4. Insure the mounting surface is clean and dry
as required for good adhesion. Apply silicone
into the hole in the wall as required to create
a moisture seal. Hold the control with the LED
display in the 12 o'clock position and press
the control against the wall until the adhesive
sticks and holds firmly as shown above.
