Mounting Instructions
The Audiowizard can be mounted to a wall using
the keyhole slots provided, or placed on any
horizontal surface.
AudioWizard shall be connected
to a main socket with a protective earthing connec-
tion. The socket shall remain readily accessible.
mr
.
steam
®
I N S TA L L AT I O N
AudioWizard
™
2.0
__________________________________________________________________
4
AW Control Cable Installation
Do not force or twist cable connectors together.
Forcing or twisting cable connectors may damage the connectors.
Do not route the AudioWizard control cable inside conduit together with power
wires, close to hot water or steam piping. Do not strain, staple, pinch or otherwise damage the
AudioWizard control cable. Doing so may result in an inoperative installation.
Route the AudioWizard control cable from the AudioWizard to the desired control location.
If using an iSteam control see the iSteam Control IOM (PUR 100477) for complete details
on locating and installing the iSteam control.
AW Control Installation
(The AW control is not required when
used with an iSteam Control.)
To install the AW control, select the most
convenient location for the control. A
1” diameter hole is needed to mount the
control. Clean the surface, peel the back-
ing paper from the adhesive on the con-
trol, run a bead of silicone around the back
of the control to ensure a wtaer tight seal
and insert the control into the hole (see
illustration).
Pull off
adhesive gasket
Outside of control
SI
LI
CO
NE
1” diameter
CAUTION
!
CAUTION
!
All drawings are for illustrative purposes only.
Locating the AudioWizard
The AudioWizard control cable is 30ft and the power
cord is 6ft, ensure the control and AudioWizard are
located accordingly.
Locate in a dry location where the wireless signal will
not be interrupted. Test Bluetooth
®
signal before
mounting AudioWizard.
ELECTRIC SHOCK HAZARD!
To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture. DO NOT
install AudioWizard in the steam room or any location
where it may become wet.
WARNING
!
WARNING
!
IMPORTANT NOTE:
A hole larger
than 1 inch diameter will not be
sealed or covered by the AW Control.
