mr. steam AudioSteam3, Инструкция по установке, эксплуатации и обслуживанию, Страница: 6 / 15

Figure 3
Figure 4
Figure 5
All drawings are for illustrative purposes only.
mr
.
steam
®
*/45"--"5*0/01&3"5*0/"/%."*/5&/"/$&
"VEJP!4UFBN
®
*/45
"--&3
Figure 3 shows the face-on dimensions of AudioSteam3.
Figure 4 shows the side-view dimensions of AudioSteam3.
Shock hazard . Do not place the control box
in a location where it can get wet.
Locating and Installing AudioSteam3
To prevent water from getting inside the device, AudioSteam3 should be
mounted on two stable vertical surfaces (e.g., studs) as shown in Figure 5 .
Using screws and washers, firmly attach AudioSteam3 using the upper
mounting holes, one at a time, on each side of the unit. Repeat the process
for the lower mounting holes ( Figure 5 ).
A clearance of at least 0.75” (19 mm) is required to ensure free
heat circulation at the back of the unit.
6
AudioSteam3 ®
2. Installing AudioSteam3
AudioSteam3 Dimensions
IMPORTANT NOTES
1. The following materials (not included) are recommended to install
AudioSteam3:
•Four #10 screws of appropriate length with round, truss, or
pan head.
•Four washers with 0.5” outer diameter x 0.0625” thickness
(12 mm outer diameter x 1.5 mm thickness).
2. To prevent over temperature shutoff and equipment damage, do not
use foil insulation in front of AudioSteam3.
3. Place AudioSteam3 far from any electrical noise source, such as
variable speed controls and motors, to prevent interference that will
affect audio quality.
4. In the event of an over temperature condition, AudioSteam3
automatically reduces the volume to protect the amplifier from
damage.
5. To prevent over temperature shutoff, do not locate in an attic or other
location where ambient temperature may reach 140 °F (60 °C).