Priming the Pump
1. Insure MrSteam fragrance container is full.
2. Insert a short piece of soft injector tube onto the tip of
the injector (see Fig. 1).
3. Insert the open end of the injector tube onto the
pressure valve (see Fig. 1).
4. Open the priming valve by turning the knob counter
clockwise one full revolution.
5. Draw liquid from the injector slowly and evenly.
Continue until the injector is full of liquid.
6. If you have drawn up the injector completely and no
liquid is in the injector, remove the injector tube from
the pressure valve.
7. Drain injector. Repeat steps until the injector is filled.
8. Save the fragrance injector as it may be needed when
new fragrances are used.
9. Close the priming valve completely by turning the
knob clockwise.
Failing to close the valve will result in
fragrance leaking from the priming port.
IMPORTANT NOTE:
If an extended pressure tube is
special ordered then contact MrSteam Technical Service
(see page 20) for instructions for filling the pressure tube
with fragrance.
Priming Valve Knob
Soft Injector Tubing
Injec
tor
CAUTION
!
Figure 1
9
I N S T A L L E R S E C T I O N
AromaFlo
Operation and Installation Instructions
®
All Drawings for Illustrative Purposes Only