5
HOW TO USE YOUR ICE CREAM MAKER (CONT.)
10.
Now prepare the bucket by filling it
with ice to the top of the canister.
11.
Add 1-2 cups of rock salt to the top of
the ice inside the bucket.
12.
Run the cranking system for
approximately 5 minutes so that the
canister chills evenly.
13.
As the ice begins to melt down by 2-3
inches, add more ice and more cups
of rock salt into the bucket.
14.
Allow the machine to churn for 45
minutes (If the motor has stopped
prematurely, turn the motor off, break
up any ice blockages with the plastic
stirrer and start it up again).
15.
Once the churning is complete (the motor
will automatically shut off when the
contents inside become too thick for the
blending spatula), unplug and remove the
motor. Clear the ice and salt away from
the lid of the canister to prevent it from
falling into the canister of ice cream.
16.
Remove the cover and carefully lift out
the Blending Spatula and scrape off any
excess ice cream.
17.
The ice cream consistency is very fresh
so it will be more of a soft-serve texture.
18.
If a harder consistency is desired,
transfer the contents to a freezable
container and freeze for 3-4 hours.
HELPFUL TIPS & NOTES
1.
Make sure to use ice that is crushed
inside the bucket. Ice should be
small, coarse pieces.
2.
As the canister is turning, make sure
to periodically mix the salt and ice
together by using the plastic stirrer
every 10-15 minutes while the
machine is in use.
3.
It is recommended to store the ice
cream inside the freezing canister.
4.
If the ice cream consistency is too
soft, put the contents into a freezable
container and freeze for 3-4 hours.
5.
Do not plug up the drainage hole on the
side of the bucket. This is for draining
excess salt water and should be kept
open at all times.
6.
If the electric motor stops churning
before the 45-minutes is complete,
check to make sure there is no blockage
of ice jamming against the canister. If
there is ice blocking the canister, turn off
the motor and remove the jammed ice.
7.
The electric motor will automatically
shut off if the ingredients in the canister
are too thick or too hard to blend
anymore. Once removed, the motor will
function normally again.
