#01 laser driver
Current Selector
2x Interlock
Laser Diode
-
+
Laser diode driver
The Mr Beam Shield features a dimmable and
efficient laser diode driver with a maximum output of
1500mA. The output current has to be set before
connecting a laser diode.
Check the data sheet of your diode for the maximum
current and place the jumper according to the
following table on the right
Setting the current too high may destroy your laser
diode.
Before connecting the laser diode check twice the
polarity of your diode, the cable and the connectors in
between. A false polarity will destroy your diode.
Interlock connectors
The shield provides 2 connectors for interlock
switches or sensors. Both have to be closed for
operating the laser.
Cooling Fan
Connect a cooling fan at this two pins. The voltage
supplied at the + pin equals the input voltage from
your power supply. The fan can be switched with the
commands M08 (on) and M09 (off).
CS1
CS2
CS3
Max Output Current
350mA
700mA
1200mA
1500mA
Cooling Fan
- +
Laser intensity
+5v
ground
pwm signal
CS1
CS2
CS3
