MPMan EB9, Руководство пользователя

Страница: 10 / 48

EN EN
17 18
Disc Brakes - Tektro
1.Check the tightness of the six disc mounting bolts
holding the brake rotor onto the wheel.If you need
to remove these bolts,be sure to us a thread-locking
compound when re-installing them.
2.Make sure the two bolts securing the caliper adaptor
bracket to the fork are tight.
3.Thread the brake cable through the caliper as shown
and secure it with the cable fixing bolt.
4.Loosen the two caliper mounting bolts enough to allow
the brake caliper to float freely.
6. Using the inner pad adjusting bolt,adjust the inside brake pad so it is as close as possible
to the rotor without rubbing.
7. Using the caliper barrel adjustor,adjust the outside brake pad so it is as close as possible
to the rotor without rubbing.
Disc brakes require breaking in. Ride and use the brakes
gently for about 13 miles before using the brakes in downhill
conditions,for sudden stops,or any other serious braking.
Please be aware that your brake system will change in
performance throughout the wear-in process.The disc
brake should be cleaned before the first ride using rubbing
alcohol.NEVER use oil or similar products to clean your
disc brake system.
Avoid touching the rotor (disc) with fingers at any time.
Natually oily fingers can contaminate the rotor and/or the
brake pads and diminish the brake's effectiveness.
Brake rotors get hot!Severe injury could result from
contact with the hot rotor.Mind your legs,as well as
your hands.