MPM MOD-33, Руководство пользователя

Страница: 15 / 36

15
GB
Recharging with the battery dock:
1.
Insert the battery (27) to the battery dock (29).
2.
Connect the battery charger cable (28) to the battery dock (29). Plug the battery charger to
a power outlet. The green LED is on, which means that the battery dock (29) is connected to
the battery charger (28). The red LED stays on for the duration of recharging the battery (27).
3.
The red LED goes off when the battery is full.
4.
Unplug the battery charger (28) from the mains and install the recharged battery in the vac-
uum cleaner.
Recharging the battery plugged to the vacuum cleaner:
1.
Plug the battery (27) to the motor module (1).
CAUTION! The vacuum cleaner will not run when the battery is recharged via the motor module!
2.
Connect the battery charger cable (28) to the power input port (3). Plug the battery charger
to a power outlet. The Power LED (6) goes on solid red for the duration of recharging the
battery.
3.
When the battery is full the Power LED (6) turns solid green.
4.
Unplug the battery charger from the mains and its cable from the vacuum cleaner.
OPERATING THE VACUUM CLEANER
1.
Make sure that the battery is fully recharged and installed in the vacuum cleaner.
2.
Install the tools and accessories as required:
- Power brush with LED lamp (19) : for cleaning all floor types of persistent dirt; the LED
lamp provides better illumination for thorough cleaning.
- Universal power brush (21) : a smaller tool which is perfect for hard floors and carpets in
confined areas.
- Round brush tool (23) : dedicated for roller blinds, lamp lenses, mirrors, and all surfaces
which require gentle treatment.
- Slot adapter (24) : for cleaning of corners, under furniture pieces and whenever access is
too restricted for other tools.
- Universal narrow swivel brush (26) : the design helps reach high and flat surfaces.
Attach the tools either to the wand (17) or to the wand port (13).
3.
Start the vacuum cleaner with the Power switch (5). The vacuum cleaner starts with the Low
suction power level ; the Power LED (6) is solid yellow-green.
4.
Press the Power switch (5) again to choose the High suction power level ; the Power LED (6)
is solid green.
5.
Check the dust canister level (11) while vacuum cleaning. Too much dust in the dust canister
will reduce the suction power, increase the power consumption and clog the filters sooner.
CAUTION! Never overfill the dust canister! The dust must not reach above the MAX level.
CAUTION! If the suction power drops significantly, the wand or the tool is clogged and/or the dust canister is
full. Unclog the wand / tool and/or empty the dust canister.
6.
When the dust canister is full, empty it as follows:
- Stop the vacuum cleaner with the Power switch (5).
- Detach and hold the dust canister over a dust bin.