MPC F1560i, Руководство пользователя

Страница: 19 / 24

19
Installing a Wall-Mounting Arm
To install the wall-mounting arm, complete the following steps:
1
Place the wall-mounting arm or mounting plate onto the back of the
monitor. Line up the holes of the arm or plate with the holes in the back
of the monitor. (See Figure 8.)
Figure 8: Installing a Wall-Mounting Arm
2 Insert the four screws into the holes and tighten. (See Figure 8). Be
careful not to over tighten the screws.
3 Attach arm to mounting plate, if required.
4 Insert the power cable into the slot on the back of the monitor and
reconnect the video cable.
APPENDIX C — ON-SCREEN MESSAGES
Table 4: On-Screen Messages
Message Action
“Cable Not
Connected”
•
Check that the signal cable is properly
connected. If the connector is loose, tighten
the connector screws.
•
Check the DB-15 plug on the video cable for
bent pins or other damage.
“Input Not Supported”
•
Your system may be set outside the display
mode range of the monitor. Verify you are
using a compatible display mode. (See Table
5: Factory Preset Timing.)