MP sava3 Hidraulic Power Unit
1 ¼” 1 ½”
V700 - 11/2017
18/40
MTMECMPsava3_700_EN
COOLER ASSEMBLY
1.
Assemble as many hoses as required to enable the
oil input and output from the cooler (see attached table).
2.
Insert the IN and OUT hoses of the cooler into the
holes of the tank cover.
3.
To assemble the thermostat, see picture here below.
THERMOSTAT
ASSEMBLY DETAIL
The power unit has a dust protection on
the tank identification cover. Remove this
protection before installing the cooler.
REQUIRED ACCESSORIES NOT INCLUDED
INPUT
-
SAE 100 Elbow 90º Hydraulic hose
-
M G 1
” – M G ¾” Connector
-
1” hydraulic joint.
OUTPUT
- SAE 100 Elbow 90º Hydraulic hose
-
M G
¾” - M G ¾” Connector
-
¾” Hydraulic joint
ASSEMBLY ON TANK COVER
- 4 T 25-30 Silent-blocks
- 4 DIN 934 M6 nuts
- 4 DIN 7980 Ø6 Grower
- 4
DIN 9021 M6 Washers
.
IMPORTANT:
The oil cooler must not be placed at a height of more than 1100 mm
with regard to the ground where the hydraulic power unit stands.
3
•
OIL COOLING DEVICE
3.1 Oil cooling device connections - Hydraulic power unit
INPUT
OUT
