MP Biomedicals 6004-500, Инструкция по эксплуатации

Страница: 14 / 35

EMERGENCY NOTE: In case any difficulties Push the Emergency Switch to stop
the instrument at any time (on the front panel of the instrument) Ref. Fig. 1
In this, the instrument will be completely isolated from AC mains. Pull the
emergency switch again to make the instrument ready to Restart.
CAUTION:
1. Improper closing of dome will be indicated by display Cancel
2. Please do not run the instrument without the tube holder, as this may cause
damage to the motor shaft.
3. To prevent sample overheating, instrument must rest for 5-10 minutes
between runs.
4. The Instrument should be properly grounded for safe use.
Earth terminal
Temperature Indication:
In case LCD displays "SYS WARM" it is an indication that Critical Parts of the
system are getting Hot. User should provide a PAUSE before next RUN.
In case LCD displays "SYS HOT!" it is an indication that temperature of
critical parts is High. Unit will stop automatically and user will not be able to
make any
RUN untill temperare falls down to a safer value.
Overload Indication:
In case there is a wrong selection of Holder or there is a Over Load condition,
LCD will display "OverLoad" . Its an indication that User must make proper
selection of Tube Holder or reduce the number of tubes in Tube Holder.
www.mpbio.com 15