UC-8580 Series Hardware User Manual
12
Connecting Data Transmission Cables
In this section, we describe how to connect the UC-8580 embedded computer to a network and serial
devices.
Connecting to an Ethernet Network
Connect your network cable to the embedded computer’s Ethernet port. The other end of the cable should
be connected to your Ethernet network. When the cable is properly connected, the green LED corresponding
to the Ethernet port turns on indicating a valid connection.
Two 10/100/1000 Mbps Ethernet ports with M12 X-coded connectors are located on the rear panel of the
UC-8580 computer. See the following figure for the location of the Ethernet ports and the pin assignments.
The figure is based on the SMA model.
NOTE
If you are using your own Ethernet cable, make sure that the pin assignment on the connector of the
Ethernet cable matches the pin assignment shown below.
