- 8 -
Connecting the Power Supply
The M12 A-coded 5-pin male connector on the TN-5308-4/8PoE front
panel is used for the DC power input. You have to prepare a power cord
with M12 A-coded 5-pin female connector to connect the switch to the DC
power input.
Pinouts for the power input port on the TN-5308-4/8PoE
STEP 1:
Plug your power cord connector to the power input port of the
TN-5308-4/8PoE switch.
STEP 2:
Screw the nut on your power cord connector to the power input
connector on the switch to ensure a tight connection.
ATTENTION
Before connecting the TN-5308-4/8PoE to the DC power input,
make sure the DC power source voltage is stable.
Connecting the Data Lines
10/100BaseT(X) Ethernet Port Connection
All TN-5308-4/8PoE models have 8 10/100BaseT(X) Ethernet ports
(4-pin shielded M12 connectors with D coding). The 10/100TX ports
located on the TN-5308-4/8PoE’s front panel are used to connect to
Ethernet-enabled devices. Most users configure these ports for Auto
MDI/MDI-X mode, in which case the port’s pinouts are adjusted
automatically depending on the type of Ethernet cable used
(straight-through or cross-over), and the type of device (NIC-type or
HUB/Switch-type) connected to the port.
In what follows, we give pinouts for both MDI (NIC-type) ports and MDI-X
(HUB/Switch-type) ports. We also give cable wiring diagrams for
straight-through and cross-over Ethernet cables.
www.ipc2u.ru
www.moxa.pro
