- 6 -
NOTE
Please use the screws (M3 x 40 mm) packed in the panel
mounting kit.
DIN-Rail Mounting (optional)
With the optional DIN-Rail mounting kit
DK-TN-5308-4/8PoE (must be purchased
separately), you can mount the
TN-5308-4/8PoE on a 35mm DIN-Rail.
STEP 1:
Fix the DIN-Rail attachment plate onto the
rear panel of the switch as shown in the
figure at the right.
STEP 2:
Position the TN-5308-4/8PoE on
the DIN-Rail, tilting to hook
clamps over the top edge of the
rail.
STEP 3:
Swing the switch down fully onto the
DIN-Rail until both clamps
completely latch.
To remove the Moxa ToughNet Switch from the DIN-Rail, simply reverse
Steps 2 and 3 above.
Wiring Requirements
WARNING
Turn the power off before disconnecting modules or wires. The
correct power supply voltage is listed on the product label. Check
the voltage of your power source to make sure you are using the
correct voltage. Do NOT use a voltage greater than what is
specified on the product label.
These devices must be supplied by a SELV source as defined in
the Low Voltage Directive 2006/95/EC and 2004/108/EC.
www.ipc2u.ru
www.moxa.pro
