- 11 -
Console Pinouts for 10-pin or 8-pin RJ45
10-Pin Description
8-Pin
1
–
2
DSR
1
3
RTS
2
4
GND
3
5
TxD
4
6
RxD
5
7
–
6
8
CTS
7
9
DTR
8
10
–
NOTE
The pin numbers for both 8-pin and 10-pin RJ45 connectors (and
ports) are typically not labeled on the connector (or port). Refer
to the pinout diagram above for details.
LED Indicators
The front panel of the Moxa OnCell G3150A-LTE contains several LED
indicators. The function of each LED is described in the table below:
Type Color State
Description
Signal
(1 LED)
Green Blinking The number of blinks indicates the cellular
signal level (once the device is connected to a
cellular network with an IP address.)
Interval between two blinks: 200 ms
Gap: 2 seconds
Number
of Blinks
Cellular RSSI
RSSI Range
(dBm)
1
0 < SNR ≤ 12
113 < RSSI ≤
-89
2
12 < SNR ≤ 21
-
89 < RSSI ≤
-73
3
22 < SNR ≤
31
-
73 < RSSI ≤
-51
NOTE: The Cellular RSSI value is based on the
OnCell device signal strength returned by the
AT+ CSQ AT command
. You can also refer
to the equivalent signal
RSSI Range (dBm)
provided in the table above.
PWR1/
PWR2
Green On
DC power source active
Off
Power is off
Ready Green On
System startup is complete and the system is
in operation.
Blinking
(slow at
1-sec
intervals)
The OnCell device has been located by the
Wireless Search Utility.
Off
Power is off, or device is booting up.
Fault
Red
On
Device is booting up, or IP address conflict.
Blinking
(slow at
1-sec
intervals)
Cannot get an IP address from the DHCP
server