OnCell G2111/G2151I Series
Getting Started
2-3
Wiring Requirements
ATTENTION
Safety First!
Be sure to disconnect the power cord before installing and/or wiring your device.
Wiring Caution!
Calculate the maximum possible current in each power wire and common wire. Observe all electrical codes
dictating the maximum current allowable for each wire size. If the current goes above the maximum ratings,
the wiring could overheat, causing serious damage to your equipment.
Temperature Caution!
Be careful when handling the device. When plugged in, the device’s internal components generate heat and the
casing may feel hot to the touch.
You should also pay attention to the following guidelines:
•
Use separate paths to route wiring for power and devices. If power wiring and device wiring paths must
cross, make sure the wires are perpendicular at the intersection point.
NOTE
: Do not run signal or communication wiring and power wiring in the same wire conduit. To avoid
interference, wires with different signal characteristics should be routed separately.
•
Use the type of signal transmitted through a wire to determine which wires should be kept separate.
Generally, if different wires share similar electrical characteristics, they can be bundled together.
•
Keep input wiring and output wiring separate.
•
If possible, it is recommended that all device wiring be clearly labeled.
SIM Card Installation
In order to protect the SIM card, the SIM card slot is located inside the casing. You will need to unscrew and
remove the outer cover before installing or removing the SIM card.
Follow these steps to remove or install the SIM card:
1.
Unscrew the outer cover.
2.
Slide the outer cover to the left to remove it.
3.
Slide the SIM card cradle to the left and pull it towards you. Insert the SIM card into the cradle.
4.
Swing the cradle back against the unit and slide it back into place. Replace the outer SIM card cover.
www.ipc2u.ru
www.moxa.pro
