– 1 –
– 2 –
– 3 –
P/N: 1802003114401
NPort DE-311
Quick Installation Guide
Fifth Edition, June 2014
OVerview
Welcome to Moxa’s NPort Express DE-311, a compact palm-sized
data communication device that allows you to control
RS-232/422/485 serial devices over a TCP/IP based Ethernet
network.
Package Checklist
Before installing the DE-311, verify that the package contains the
following items:
•
NPort DE-311 universal serial device server
•
NPort Express Quick Installation Guide for the DE-311
•
NPort Documentation & Software CD
•
Mini adapter
Optional Accessories
•
DK-35A (for 35 mm DIN-rail, includes 4 screws)
Please notify your sales representative if any of the above items is
missing or damaged.
Hardware Introduction
Reset Button—Hold the reset button down to erase the password
or load the factory defaults, depending on how long the button is
held down:
•
3 seconds to erase the password
The ready LED will flash every half-second when the password
has been erased. You may release the reset button at this
time.
•
10 seconds to load factory defaults
The ready LED will flash five times every second when the
factory defaults have been loaded. You may release the reset
button at this time.
LED Indicators—There are three LED indicators on the top panel:
LED Name LED Color LED Function
PWR
red
Power is on
off
Power is off, or power error condition
exists
Link
orange
10 Mbps Ethernet connection
green
100 Mbps Ethernet connection
off
Ethernet cable is disconnected, or has
a short
Ready
green
System is ready
off
System error
Hardware Installation
Placement Options
You may place the unit
on a desktop or other
horizontal surface. You
may also make use of
the DIN-rail or wall
mount options, as
illustrated here.
Wall Mount
DIN-Rail
DIP Switch
The top panel contains the following table, which explains the DIP
switch settings for the serial port. The DIP switches are located at
the rear panel.
SW1
Serial
Connection
SW2 SW3
Interface Mode
ON
RS-232
Console
---
---
---
OFF
Data
Comm
OFF
OFF
RS-232
OFF
ON
RS-422
ON
OFF
2-wire RS-485 by RTS
ON
ON
2-wire RS-485 by ADDC
SW1 is used to activate the serial console. When SW1 has been
changed, the unit will reboot to initialize the new setting. You will
need to wait for the green Ready LED to turn off and then on again,
which indicates that serial console mode has been activated or
deactivated. SW2 and SW3 are used to select the serial port
interface. (Note that RTS stands for Ready To Send and ADDC
stands for Automatic Data Direction Control.)
When adjusting the DIP switches, please keep the following in
mind:
•
To use the serial port as an RS-232 console connection, such
as when using MOXA PComm Terminal Emulator or
HyperTerminal, set SW1 to the ON.
•
Some configuration may be carried out through a Telnet
connection, during which data is transmitted through the unit’s
Ethernet port. SW1 must be OFF in order for the unit to
establish a Telnet connection.
Software Installation Information
Detailed instructions for installing the included software can be
found on the NPort Documentation & Software CD in the “NPort
Family Software Installation Guide.”
