Moxa Technologies Moxa Smartio C168H, Руководство пользователя

Страница: 94 / 102

6-6
Smartio
C168H/HS User’s Manual
addresses for each port, Interrupt Vector,
IRQ, is identical to that of the driver.
c. The I/O addresses may conflict with other devices, please change another set
of I/O address such as I/O:0x280, Interrupt Vector:0x2C0.
d. The board(s) is not plugged properly. Please make sure the board is seated
firmly in the expansion slot.
e. The slot for plugging the board is defective.
In this case, please try other slots until you find a good one.
f. The board might be defective.
DOS
This section is specific for troubleshooting under DOS. For general problems and
solutions, please see the previous section, “General Troubleshooting”.
1. After executing SER-DRV.EXE, e rror message “None serial port found!”
appears.
a. Make sure you’re using the right driver.
b. Check if the board is properly plugged into ISA/EISA bus slot.
c. Check if the I/O address and IRQ settings in SETUP program are same as
the settings on board.
UNIX
This section is specific for troubleshooting under UNIX. For general problems and
solutions, please see the previous section, “General Troubleshooting”.
1. Under UNIX, when respawning quite a few number of tty ports, the
following error messages appear: “Time out table overflow”, “File table
overflow”, “Region table overflow”.
Software Cause and Solution:
The above error messages imply that the system resources are exhausted. You
should tune the kernel parameters to a larger value and rebuild the kernel to be able
to accommodate the new configuration. Refer to UNIX system manual about how
to tune the parameters and rebuild kernel.