Moxa Technologies ioPAC 5500 series, Руководство пользователя по оборудованию

Страница: 19 / 42

ioPAC 5500 Hardware Installation
2-7
The Toggle Switch
The toggle switch functions differently depending on the programming language set your ioPAC model is
configured for.
In IEC-61131-3 Models
For IEC-61131-3 models, the toggle switch is a simple run/stop switch for IEC
programs. Users can enable or disable it through RTUxpress. The default
setting is disabled.
In C/C++ Models
On models that use the C language set, the toggle switch is programmable,
giving integrators and end-users a switch that can trigger one of two
operation modes (refer to the C/C++ Sample Code Programming Guide
for ioPAC RTU Controllers for details).
Toggle Switch: Factory Reset Process
Use the following procedure to reset the ioPAC to the factory defaults. Note that when you reset the ioPAC, all
of your tag definitions, software programs, and files will be deleted, and the service and runtime engine will be
restarted.
1. When the system is booting up and the RDY LED is blinking GREEN, hold the toggle switch in the “reset”
position.
2. Continue to hold toggle switch until the “RDY” LED turns a solid RED, and then release the toggle switch. It
will take around 90 seconds to complete the factory reset process.
3. When the “RDY” LED starts blinking GREEN (indicating that the kernel is rebooting), the factory mode is
completed.
NOTE Do NOT power off, operate, or connect any devices when the “RDY” LED is a solid RED. The factory reset
function is only activated when the system is booting up.