Moxa Technologies IMC-P101 Series, Быстрое руководство по установке

Страница: 6 / 12

- 6 -
DIN-Rail Mounting
The aluminum DIN-Rail attachment plate should be fixed to the back
panel of the IMC when you take it out of the box. If you need to reattach
the DIN-Rail attachment plate to the IMC, make sure the stiff metal spring
is situated towards the top, as shown in the figures below.
STEP 1:
Insert the top of the DIN-Rail into
the slot just below the stiff metal
spring.
STEP 2:
The DIN-Rail attachment unit will
snap into place as shown below.
To remove the Moxa Industrial Media Converter from the DIN-Rail, simply
reverse Steps 1 and 2 above.
Wall Mounting (Optional)
For some applications, you will find it convenient to mount the Moxa PoE
Media Converter on the wall, as illustrated below.
STEP 1:
Remove the aluminum
DIN-Rail attachment plate
from the Moxa PoE Media
Converter, and then attach
the wall mount plates, as
shown in the diagrams below.
STEP 2:
Mounting the Moxa PoE Media Converter on the wall
requires 4 screws. Use the IMC, with wall mount plates
attached, as a guide to mark the correct locations of
the 4 screws. The heads of the screws should be less
than 6.0 mm in diameter, and the shafts should be less
than 3.5 mm in diameter, as shown in the figure at the
right.
NOTE Test the screw head and shank size by inserting the screw into
one of the keyhole shaped apertures of the Wall Mounting Plates,
before it is screwed into the wall.
Do not screw the screws in all the way—leave a space of about 2 mm to
allow room for sliding the wall mount panel between the wall and the
screws.