- 7 -
WARNING
Hot Surface. Do not touch.
ATTENTION
The SFP module only supports Laser Class 1 optical transceivers.
Grounding the IEF-G9010-2MGSFP Series
Grounding and wire routing help limit the effects of noise due to
electromagnetic interference (EMI). Run the ground connection from the
ground screw (M4 type) to the grounding surface prior to connecting
devices.
ATTENTION
This product is intended to be mounted to a well-grounded
mounting surface such as a metal panel.
Wiring the Relay Contact
The IEF-G9010-2MGFFP Series has one set of relay outputs. The relay
uses two contacts on the terminal block of the IEF-G9010-2MGFFP Series
front panel. Refer to the
Wiring the Redundant Power Inputs
section
for instructions on how to connect the wires to the terminal block
connector, and how to attach the terminal block connector to the terminal
block receptor.
The diagram below indicates the location of the relay contacts on the
terminal block.
Top View
Right View
Fault:
The two contacts of the
2-pin terminal block connector are
used to detect user-configured
events. The two wires attached to
the fault contacts form an open
circuit when a user-configured
event
is
triggered. If a
user-configured event does not
occur, the fault circuit remains
closed.
Wiring the Redundant Power Inputs
The IEF-G9010-2MGSFP Series has two sets of power inputs—power
input 1 and power input 2. The top and side views of the terminal block
connector are shown below.
