- 9 -
FAULT:
The two contacts of the 6-pin terminal
block connector are used to detect
user-configured events. The two wires
attached to the fault contacts form an
open circuit when a user-configured
event is triggered. If a user-configured
event does not occur, the fault circuit
remains closed.
Wiring the Redundant Power Inputs
The EDS-G500E series has two sets of power inputs—power input 1 and
power input 2. The top and front views of one of the terminal block
connectors are shown here.
STEP 1:
Insert the negative/positive
DC wires into the V-/V+ terminals,
respectively.
STEP 2:
To keep the DC wires from
pulling loose, use a small flat-blade
screwdriver to tighten the wire-clamp
screws on the front of the terminal
block connector.
STEP 3:
Insert the plastic terminal
block connector prongs into the
terminal block receptor, which is
located on the EDS-G500E’s top panel.
Wiring the Digital Inputs
The EDS-G500E series has one set of digital input (DI). The DI consists of
two contacts of the 4-pin terminal block connector on the EDS-G500E's
top panel, which are used for the two DC inputs. The top and front views
of one of the terminal block connectors are shown here.
STEP 1:
Insert the negative
(ground)/positive DI wires into the
┴
/I terminals, respectively.
STEP 2:
To keep the DI wires from
pulling loose, use a small flat-blade
screwdriver to tighten the wire-clamp
screws on the front of the terminal
block connector.
STEP 3:
Insert the plastic terminal
block connector prongs into the
terminal block receptor, which is
located on the EDS-G500E’s top panel.
Communication Connections
Each EDS-G500E series switch has 4 types of communication ports:
•
1 USB console port (type B connector)
•
1 USB storage port (type A connector)
•
8 (EDS-G508E/EDS-G512E-4GSFP) or 12 (EDS-G516E-4GSFP)
10/100/1000BaseT(X) Ethernet ports
•
4 100/1000Base SFP slots (EDS-G512E-4GSFP/EDS-G516E-4GSFP)
Содержание EtherDevice EDS-G508E
Страница 5: ...5 Mounting Dimensions Unit mm inch...
