EM-1220 LX User’s Manual
Getting Started
2.
You may also configure the EM-1220-LX to request IP addresses from a DHCP server. In this
case, use the sharp sign (#) to comment out one or both “ifconfig” lines, and then add the
setting about the “dhcpcd” into the rc file as below.
dhcpcd -p -a eth0 &
dhcpcd -p -a eth1 &
Note that the EM-1220-LX will send out DHCP broadcast packets, and then get the IP
addresses from the first DHCP server that responds.
3.
Issue the vi “write” command to save the file, and then reboot. Since the EM-1220-LX only
reads the “rc” file when booting up, you must reboot (e.g., by issuing the vi
reboot
command) for the changes to take affect.
ATTENTION
You may reset the IP address immediately by issuing the command
ifconfig eth0 192.168.5.127
(This will change the IP address of LAN1.) Issuing this command will
NOT
however update the
“rc” file in the EM-1220-LX’s flash memory, so the next time you reboot, the IP address will
revert to its previous value.
2-5
