CAN Interface Board User’s Manual Hardware
Installation
Hardware Installation Procedure
Use the following simple procedure to install the Moxa CAN interface board in your computer.
1.
Shut down the computer and remove the computer’s outer cover.
2.
Insert your CP-602U-I, CP-602E-I, or CB-602I board into a suitable empty slot.
3.
Replace the computer’s outer cover and turn on the computer.
Configuring the Board and Dimensions
CP-602U-I
CP-602U-I
106.3 mm (4.19 in)
58 mm (2.28 in)
82 mm (3.23 in)
120 mm (4.72 in)
120.5 mm (4.74 in)
JP1
JP3
101.07 mm (3.98 in)
Port 1
Port 2
Terminal Resistor
Onboard termination resistors can be activated individually for each CAN controller using a
jumper.
Jumper Description
Status
Enabled Disabled
JP1
Jumper settings for port 1 termination
resistor (120
Ω
)
Enabled Disabled
JP3
Jumper settings for port 2 termination
resistor (120
Ω
)
2
2
1
1
2
2
1
1
2-2
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-9622-Moxa-CP-602U-I.aspx
