Mouvex 15L, Инструкция по эксплуатации, обслуживанию и безопасности

Страница: 13 / 16

- Coat the surface for contact between the body and
the multiplier with Loctite ® 510*.
- Grease the lip joint 822 .
- Centre the shaft 809 in the bearing 808 and engage
the lip joint 822 , and, in the same movement, engage
the centring between the compressor and the multi-
plier.
- Place Loctite ® 243* on the short screws 836 and
washers 838 keeping the body of the multiplier in
place 801 . Screw at torque 24 Nm + 10%. Start
screwing with the 2 opposite screws, screwed gra-
dually, ckecking that the multiplier drive shafts can
rotate freely.
- Place Loctite
®
243* on the screws 837 and washers
838 keeping the body of the multiplier in place 801 .
Screw at torque 24 Nm + 10%. Check that the multi-
plier drive shafts rotate freely.
- Place Loctite ® 243* on the screws 835 and rings BS
834 keeping the lid in place 3 . Screw at torque 24 Nm
+ 10%.
- Unscrew the screw holding the fan in place 819 . Inject
a drop of Loctite ® 243*. Replace the screw.
- Mount the fan 819 and screw up the relevant screw
to screw it to the shaft 809 . NB the fan wings can cut ;
use suitable protection. Wipe off the excess Loctite ® *.
- On the cover 820, check the presence of spacers 826
in the sleeves 827 .
- If necessary, depending on the drive shaft, change
the shaft position protector 832 .
- Put the cover 820 in place.
- Place Loctite ® 243* on the screws 830 through the
sleeve 827 and the spacer 826 to hold the cover 820
in place. Screw at torque 24 Nm + 10%.
• Engage the spacer 831 on the multiplier drive shaft.
• Mount the key.
• If necessary, replace the torque limiter.
Tightening screw
delivered with the fan
Short
Loctite ® 510*
13/16
NT 1401-G00 10 18 TYPHON II e
* Loctite ® is a registered trademark.
3. MULTIPLIER 13R/15L - 19R/22L (continued)