SILICON VALLEY HEADQUARTERS
1080 North 11th Street, San Jose, CA 95112 | Phone: (408) 292
FGA ADJUSTABLE
OPERATING INSTRUCTIO
Rev 1.0 (6/15/2022)
How to Indentify a FGA v2 model
There are two ways to identify whether you have a v2 or a v1 model.
1. The v2 models has separate battery access cover (see page 2) on the lower side of the
handle. The v1 models does not.
2. Second option is to move the locking bar
knob (CCW direction) below the torque range capacity. Once you pass the letter "L," if it
displays a firmware version, the model is a v2 model.
Power on Display
Press the black lever button to view the digital display and current tool
Sleep Mode
When there is no activity of pressing the lever butting or adjusting the setting,
the display will timeout approximately within 20 seconds and then goes into
Sleep mode. Press the black lever button to aw
Adjusting
the Torque Setting
Units of Measurement
Press the black lever button while the display is powered on
torque measurement unit options available for
FGA Models
Torque Measurement Units
FGA-8, FGA-20 & FGA-40
ozf.in, lbf.in, cN.m, N.m, kgf.cm
FGA-80
Torque Setting
Slide the locking bar slide mechanism to the unlock position. Use the black adjustment knob to change torque settings. Turn
the knob clockwise to increase torque and counterclockwise to decrease torque. After selecting your torque value, release the
locking bar slide, and it will return to its original position.
bottom-up.
1080 North 11th Street, San Jose, CA 95112 | Phone: (408) 292-2214 | Fax: (408) 292-2733 | mountztorque.com
ADJUSTABLE TORQUE SCREWDRIVER
OPERATING INSTRUCTIONS
There are two ways to identify whether you have a v2 or a v1 model.
The v2 models has separate battery access cover (see page 2) on the lower side of the
Second option is to move the locking bar slide into the unlock position and adjust the
knob (CCW direction) below the torque range capacity. Once you pass the letter "L," if it
displays a firmware version, the model is a v2 model.
igital display and current tool setting.
When there is no activity of pressing the lever butting or adjusting the setting,
the display will timeout approximately within 20 seconds and then goes into
Sleep mode. Press the black lever button to awake the tool from Sleep mode.
while the display is powered on to toggle through
for your FGA model.
Torque Measurement Units
ozf.in, lbf.in, cN.m, N.m, kgf.cm
lbf.in, N.m, kgf.cm
Slide the locking bar slide mechanism to the unlock position. Use the black adjustment knob to change torque settings. Turn
increase torque and counterclockwise to decrease torque. After selecting your torque value, release the
locking bar slide, and it will return to its original position.
Per ISO:6789-1, when certified, the tool is adjusted from the
1
v1 model
v2 model
SCREWDRIVER (V2)
Slide the locking bar slide mechanism to the unlock position. Use the black adjustment knob to change torque settings. Turn
increase torque and counterclockwise to decrease torque. After selecting your torque value, release the
1, when certified, the tool is adjusted from the
